TEAM DUCTALES Enigma-2


Short Instruction for Installing E2
1. update the boot loader to use USB booting.
2. input uImage and root.img to a good quality USB memory stick.
4. connect the USB memory stick to the receiver.
5. press CHANNEL DOWN KEY in the front panel, and then turn on the receiver by A/C power button in rear panel.
6. the front panel will display ON or OFF.
* ON means booting from USB memory stick is activated.
- If the usb memory stick of E2 image is connected to the receiver, the receiver will boot E2 image from USB memory stick.
- If the usb memory stick of E2 image is NOT connected to the receiver, the receiver will boot the Xcruiser from the intenal memory.
* OFF means booting from USB memory stick is NOT activated, so it will boot only Xcruiser from internal memory.
* ON/OFF will be changed to each other by pressing CHANNEL DOWN KEY in the front panel when you turn on the receiver.


Important Notes:-
* When turn off the receiver, go to deep standby mode by pressing power button for around 4seconds in Remote.
otherwise channel date couldn't be saved and/or booting fail could happen.
In case of booting fail, you have to turn off/on & reboot 1~2times to recover.
* If the USB memory stick is old and low quality, booting from USB could be fail.
In this case, use a better quality USB memory stick and try again.


FTP Username and Password
Username :- root
Password :- dreambox

اسمون ابری بود با نگاه من